Search Results

You searched for "gsx-r1000,"

33 FAQs Found Page 1 of 4
	Can you send me a map with the secondary throttle plates removed for a GSX-R1000? Also does Pair valve sucker mod in place mean that the Pair valve has been removed?
	Clutch mod and HD springs: I have both in my Suzuki GSXR 1000 05". What I need help with is the clutch adjustment after both are installed. I see there are 3 adjustment areas; 1) the lever 2) the clutch release adjuster cap 3) and the clutch cable adjuster under the tank. How should all three be adjusted for the correct setting? Here is what I've noticed, when I leave free play at the lever it's hard to engage the gears but when it's tight at the lever it's no problem. I've followed your instructions to the tee and still it boggles me. I guess I don't know what I should expect with having your mods in there. Also where should the clutch start to grab? Very soon from the handle or in the middle? This has been racking my brain since I've owned the bike.
	I installed your ultra clutch mod and yellow springs. Now, when I am on the line can I just dump it (does it drag or slip by itself and then bite) or do I still have to drag it? Is there more than one way of setting the clutch? I saw something about washers behind the springs? I am running 14-46 gearing and trying to keep the front end down through the end of first. I have a GSX-R1000 that's lowered and strapped with weights.
	I have a 07 Hayabusa I’d like to wake up a bit, my last bike was a stock 05 GSX-R1000. I'd like to also think reliability as I've got a touring set up for it to take 5 and 6 hour trips. From suggestions I'm looking at the intake cam for exhaust, your Gen3 pipe, Power Commander. And local guy mentioned removing a gasket that would bump the compression a half or so. ? got me... he is reputable wrench/builder though. Does any of this sound as good reliable set up for my 07 Hayabusa?
	Do pair block offs work with the GSX-R1000?
	Does the oil cooler removal kit work for the GSXR1000?
	I have a 2006 Gsxr1000, today I tried to start my bike and the only thing it did was turn over. I checked my gas tank it was low on fuel so I put some fuel in it, but it still wouldn’t start. I checked the fuses and the battery and there was nothing wrong with them. Could the spark plugs be fouled?
	I'm currently in need of suspension help on my 05 gsxr 1000. Do you have any advice on setting my STOCK shock on my bike. I am approx. 8 over and weigh 185 lbs. I believe my suspension is to blame for not getting my u-soft to hook with stock engine. Stock shock setup
	I've ordered and installed your clutch cushion mod for the 01-04 GSX-R1000. Would it defeat the purpose if I put the cushion in but left the stock springs in? With all 5 of the HD springs in the clutch lever it is very difficult to pull in, especially in traffic. Im not that big of a guy, at only 130lbs fully suited.
	What is the clutch stack height for an 01-04 GSX-R1000 when I remove a plate to make 8 steels and 8 fibers? I installed a clutch cushion for the back dated clutch on my 06 and have some OEM thick, thin steels, and fibers.
Go to Page : 1234

Can't Find an Answer? If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.