Search Results

You searched for "difference"

100 FAQs Found Page 1 of 10
	I have a 2009 ZX-14 and I recently installed a 40 shot nitrous kit for track use. I'm looking for advice on strengthening the clutch. How much stiffer is the clutch with each of your spacers? What set up would you recommend for my use? Clutch springs and spacers
	I just received the maps for my 04 hayabusa with a full street meg/stock air box used for mostly high performance street riding. I'm curious if the track map can be used on the street with pump gas with out danger/harming my bike? Or am I better off using the street tune? What map to use
	I have an 08 ZX-14 with a ShortMeg, secondaries removed, tre, BMC race air filter, and a PC5 with Brock's map. My question is will a Brock's flashed ECU help me pick up more power?
	Replacement parts such as headers and mid pipes..Does Brock sell these items individually or if the part is damage you have to purchase a whole new full system? ..I see there is no section on yur site for order replacement parts other than mufflers
	On The CT Series Systems Headers..What Is The Difference Between The gen1 And Gen2 Headers? Difference between Gen1 & Gen2
	I have just installed your Full System Black with a short Meg. I have an exhaust leak on left side header. What are the torque settings for the 2 header securing nuts? Torque on flanges
	I'm really stuck between buying the CT full system or the alien head system. Can you give me a quick run down of the differences between the two or pros and cons etc?? Difference between stainless and titanium
	I purchased (ordered through local dealer) a new full Titanium system with CT Meg and a PC V with street tune for my zx 14r 2012 everything is great, no issues. Q; If I install a BMC race filter will any additional tune be needed? Q; If I install Velocity Stacks (23mm) will additional tune be needed. I like the intake howl thus the reason for the VS install. Extra feed back on this welcomed. TY Mapping changes
	Hello, where can I get installation instruction to install a Brock's sidewinder on my 07 gsxr1000.
	I installed my new CT series exhaust on my ZX-14R and the studs on the head do not engage enough of the nut to even be flush when torqued to 10ft/lbs.
Go to Page : 12345678910

Can't Find an Answer? If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.