You searched for "Torque"
10 FAQs Found
Page 1 of 1
I have a '07 ZX14 and I'm considering your Street Meg pipe but have a few questions. 1)I already have a PC3 Power Commander and the secondary throttle plates out(map 011),what horsepower and torque gain can I expect after remapping with your pipe? 2)What is the cost including shipping to Edmonton,Ab.Canada including all fees? 3)Does a full system have an advantage over slip-ons other than weight saving?
I am installing your Ultra Light Billet Clutch Mod for my Busa. I can remove the nut from the hub assembly with an impact gun, but I do not feel comfortable using it to install the nut. I would like to torque this to the manufacturer spec. Where can I find the tool illustrated (the Clutch Hub Holder) that is shown on your instruction paper?
I have spent some time rereading your ZX-14 Diaries. I know that your recommendation is for the best due to the variable nature of torque output applied to the pavement when removing "The Flies". It seems to me, that since I will be riding in all weather conditions, I must maintain that aspect of "Driveability" you spoke of in your last email. Especially since traction will constantly be an issue.
I have a 2008 hayabusa and purchased the front/rear sprockets from you. What are the torque spec's for the front sprocket and the rear sprocket nuts?
What is the torque spec for sprocket bolts for a BST wheel?
What torque should I use when fitting the BST wheels?
I have a 2008 Suzuki Hayabusa and I purchased one of your CT single exhaust systems. What torque spec do you use on the header flanges?
CT single header flanges torque
I installed my new CT series exhaust on my ZX-14R and the studs on the head do not engage enough of the nut to even be flush when torqued to 10ft/lbs.
I'm looking at buying one of your exhausts. I'm looking at the CT single full 16" system or the CT Megaphone Full 17" system. I was curious what the differences are in performance(hp,torque) and weight?
I have just installed your Full System Black with a short Meg. I have an exhaust leak on left side header. What are the torque settings for the 2 header securing nuts?
Torque on flanges
Go to Page :
Can't Find an Answer?
If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.